LiftLoggr estimate
455.6 lb
Brzycki, from 405 lb × 5. The formula the app uses for estimated 1RM and PRs. RIR isn't used.
Other estimates (web only)
- Epley
- 472.5 lb
- RIR-adjusted: 2 RIR, as 7 reps to failure
- 486 lb
| % 1RM | Weight |
|---|---|
| 100 % | 456 lb |
| 95 % | 433 lb |
| 90 % | 410 lb |
| 85 % | 387 lb |
| 80 % | 364 lb |
| 75 % | 342 lb |
| 70 % | 319 lb |
| 65 % | 296 lb |
| 60 % | 273 lb |
| 55 % | 251 lb |
| 50 % | 228 lb |
| Reps | % 1RM | Weight |
|---|---|---|
| 1 | 100 % | 456 lb |
| 2 | 97.2 % | 443 lb |
| 3 | 94.4 % | 430 lb |
| 4 | 91.7 % | 418 lb |
| 5 | 88.9 % | 405 lb |
| 6 | 86.1 % | 392 lb |
| 7 | 83.3 % | 380 lb |
| 8 | 80.6 % | 367 lb |
| 9 | 77.8 % | 354 lb |
| 10 | 75 % | 342 lb |
| 11 | 72.2 % | 329 lb |
| 12 | 69.4 % | 316 lb |
Rounded to the nearest 1 lb. Reps table: Brzycki inverted, 1–12 reps.
Key takeaways
- 01Deadlift max ≈ weight × 36 ÷ (37 − reps). 180 kg × 3 → 190.6 kg.
- 02Rep formulas tend to underestimate the deadlift. Treat the number as a floor.
- 03Estimate from dead-stop reps in sets of 1 to 5.
- 04Grip often fails before the back on high reps. Straps change the estimate.
On this page
Your deadlift max is about weight × 36 ÷ (37 − reps) from a set to near failure: 180 kg × 3 gives 190.6 kg; 405 lb × 2 gives 416.6 lb. That’s Brzycki, the LiftLoggr formula. On the deadlift, treat it as a floor: rep formulas tend to underestimate this lift.
The calculator above is set to the deadlift. The first figure is the LiftLoggr estimate; Epley and the RIR-adjusted figure are labelled extras. Full rules: 1RM calculator.
Deadlift examples
| Set | Estimated max | Epley (extra) |
|---|---|---|
| 140 kg × 10 | 186.7 kg | 186.7 kg |
| 180 kg × 3 | 190.6 kg | 198 kg |
| 200 kg × 5 | 225 kg | 233.3 kg |
| 250 kg × 2 | 257.1 kg | 266.7 kg |
| 315 lb × 5 | 354.4 lb | 367.5 lb |
| 405 lb × 2 | 416.6 lb | 432 lb |
| 495 lb × 3 | 524.1 lb | 544.5 lb |
LiftLoggr keeps Brzycki on every lift, so your estimates compare across exercises and over time. On the deadlift, expect your true single to land above it.
Why formulas miss on the deadlift
In LeSuer et al. (1997), all seven equations tested underestimated the tested deadlift max, despite correlating closely with it. The deadlift is built differently from the bench and squat:
- No stretch reflex. Every rep starts from a dead stop. There’s no lowering phase to bounce out of, so reps 4, 5 and 6 cost more than on a squat.
- Grip and lower back tire first. On a set of 8, the hands and the spinal erectors often give out before the legs and hips do. A single doesn’t run into that.
- Technique breaks down across reps. Later reps drift: hips rise early, the bar moves forward. A fresh single is your best technique of the day.
So use the deadlift estimate as a floor. Sets of 1 to 5 give the most useful numbers; a 10-rep set mostly measures grip and conditioning.
Conventional, sumo and trap bar
Estimate each pull from its own sets. Many lifters are noticeably stronger in one stance, and a sumo max says little about a conventional one. The trap bar is easier at the start for most people, so a trap-bar estimate usually reads higher than a straight-bar one. Romanian deadlifts start from the top and skip the floor entirely: use them to track hamstring strength, not to estimate a deadlift max.
Testing a true deadlift max
- Warm up with the deadlift warm-up calculator. Raise light plates to standard height so the warm-ups start where the max will.
- Single at about 90 %. Rest 3 to 5 minutes.
- Single at about 95 %. Switch to your max grip here: mixed, hook or straps if allowed.
- One attempt. If the bar breaks the floor but stalls at the knees, that’s today’s limit. Log the heaviest completed pull.
Heavy single cues. Bar over mid-foot. Grip, then pull the slack out until the bar clicks against the plates. Brace hard. Push the floor away; don’t yank. Lock out with the hips, shoulders back, no lean-back.
Safety
- Lower it under control all the way to the floor. Dropping a max from lockout damages kit and is banned in many gyms.
- Stop the attempt if the back rounds far more than on your warm-ups. A rep that looks different is the wrong rep to grind.
- Mixed grip: keep the underhand arm straight. Curling with it is how biceps tears happen at heavy loads.
- Clear space around the platform. No one behind or beside the bar.
In the app
LiftLoggr calculates this estimate for every completed deadlift set you log, keeps your best as a record and charts it over time. Conventional, sumo and Romanian deadlifts are separate catalog exercises, so each keeps its own estimate.
Questions
How do I calculate my deadlift max from reps?
Take a set close to failure and use weight × 36 ÷ (37 − reps). 180 kg × 3 gives 190.6 kg; 405 lb × 2 gives 416.6 lb. The formula stops at 12 reps.
Why do 1RM calculators underestimate my deadlift?
Deadlift reps start from a dead stop and get harder as grip and the lower back tire, so rep sets underrate what you can pull once. In LeSuer et al. (1997), all seven equations tested underestimated the tested deadlift max.
How much should I deadlift?
Among raw competitive powerlifters in OpenPowerlifting, the median best deadlift is 215 kg for men in the 83 kg class and 127.5 kg for women in the 63 kg class. Most gym lifters are below that. Compare yours in the strength standards tool.
Do touch-and-go reps count?
They give a higher estimate than dead-stop reps, because the bounce helps. If you'll pull your max from the floor, as you will, estimate from dead-stop reps.
Should I use straps on sets I estimate from?
Be consistent. A strapped 5-rep set estimates a strapped max. If you'll test without straps, your grip may be the limit, not your back or legs.
Sources
- LeSuer et al. 1997, Prediction equations for 1-RM in the bench press, squat and deadlift doi.org
- Brzycki 1993, Predicting a one-rep max from reps-to-fatigue doi.org
- IPF Technical Rules (deadlift) powerlifting.sport
- OpenPowerlifting (competition data) openpowerlifting.org