Get the app (opens the App Store in a new tab)

Tools

Deadlift warm-up calculator

The deadlift starts from the floor, and small plates start lower. Plan the first sets around that.

lb
Unit
Bar and plates
Bar
Plates in your gym

4 warm-up sets before 315 lb

4 warm-up sets before 315 lb.
SetWeightRepsPer side (lb)
Warm-up 145 lb10Bar only
Warm-up 2155 lb545 · 10
Warm-up 3220 lb345 · 35 · 5 · 2.5
Warm-up 4270 lb145 · 45 · 10 · 10 · 2.5
Working set315 lb—45 · 45 · 45

Bar × 10, then 50 % × 5 and 70 % × 3, plus 85 % × 1 when the working weight is at least twice the bar. Each load is the nearest one your plates make (ties go down).

An empty bar sits low. Pull the bar set from blocks or as Romanian deadlifts, or skip it and start at the first plated set.

The same ramp LiftLoggr builds from your first working set.

Key takeaways

  1. 01Deadlift ramp: bar × 10, 50 % × 5, 70 % × 3, 85 % × 1 of the first working set.
  2. 02Only full-size plates (450 mm, usually 20 or 25 kg / 45 lb) put the bar at standard height.
  3. 03Pull light sets from blocks or as RDLs if the bar starts too low.
  4. 04Double overhand on warm-ups. Save the mixed grip or straps for heavy sets.
On this page

For the deadlift, warm up with the bar for 10, then 50 % × 5, 70 % × 3 and 85 % × 1 of your first working set. At 180 kg that’s 20 × 10, 90 × 5, 125 × 3, 152.5 × 1; at 405 lb it’s 45 × 10, 200 × 5, 285 × 3, 345 × 1.

The calculator above is set to the deadlift. It rounds each set to plates you can load and shows the plates per side. On the deadlift, which plates matter as much as the total, because they set the height of the bar.

Deadlift ramps, worked out

Default 20 kg or 45 lb bar, standard plates.

Working set Warm-ups Plates per side Work set plates
100 kg 20 × 10 · 50 × 5 · 70 × 3 · 85 × 1 — · 15 · 25 · 25 + 5 + 2.5 25 + 15
140 kg 20 × 10 · 70 × 5 · 97.5 × 3 · 120 × 1 — · 25 · 25 + 10 + 2.5 + 1.25 · 25 + 25 25 + 25 + 10
180 kg 20 × 10 · 90 × 5 · 125 × 3 · 152.5 × 1 — · 25 + 10 · 25 + 25 + 2.5 · 25 + 25 + 15 + 1.25 25 × 3 + 5
220 kg 20 × 10 · 110 × 5 · 155 × 3 · 187.5 × 1 — · 25 + 20 · 25 + 25 + 15 + 2.5 · 25 × 3 + 5 + 2.5 + 1.25 25 × 4
315 lb 45 × 10 · 155 × 5 · 220 × 3 · 270 × 1 — · 45 + 10 · 45 + 35 + 5 + 2.5 · 45 + 45 + 10 + 10 + 2.5 45 × 3
405 lb 45 × 10 · 200 × 5 · 285 × 3 · 345 × 1 — · 45 + 25 + 5 + 2.5 · 45 + 45 + 25 + 5 · 45 × 3 + 10 + 5 45 × 4
495 lb 45 × 10 · 245 × 5 · 345 × 3 · 420 × 1 — · 45 + 45 + 10 · 45 × 3 + 10 + 5 · 45 × 4 + 5 + 2.5 45 × 5

Every percentage goes to the nearest total your plates can build, ties to the lighter one. The full rules are on the warm-up calculator page.

The bar height problem

A deadlift starts from the floor, so the height of the bar depends on the biggest plate on it. Full-size plates are 450 mm across, the competition maximum, and put the bar at standard height. Anything smaller starts the pull lower.

Set Biggest plate (kg) Bar height
100 kg at 50 %: 50 kg 15 kg iron Low, unless the 15s are bumpers
140 kg at 50 %: 70 kg 25 kg Standard
180 kg at 50 %: 90 kg 25 kg Standard
225 lb at 50 %: 110 lb 25 lb Low
315 lb at 50 %: 155 lb 45 lb Standard

Three fixes, in order of preference:

  1. Raise the plates. Stand them on blocks, mats or a pair of plates so the bar sits at standard height. Same rep, same position.
  2. Use the bar set as RDLs. Ten Romanian deadlifts from the hang warm the hamstrings and rehearse the hinge without needing the floor.
  3. Load full-size light plates if your gym has 5 or 10 kg bumper plates of full diameter.

Don’t pull from a deficit by accident. Starting lower changes the lift, so it isn’t a warm-up any more.

What each deadlift set is for

Set What to check
Bar × 10 Hinge pattern. Bar over mid-foot, shins to the bar, hips back. RDLs are fine here.
50 % × 5 Dead stop every rep. Take the slack out of the bar before it leaves the floor.
70 % × 3 Belt on if you wear one. Brace, then pull. Double overhand.
85 % × 1 Exactly like a work rep: setup, grip, brace, speed off the floor. Switch grip here if you need to.

Deadlifting after squats: the legs and hips are warm. Start at the 50 % set.

Heavy deadlift cues

  • Bar over mid-foot, about 2–3 cm from the shins. It shouldn’t move forward before it leaves the floor.
  • Pull the slack out. Lock the arms and pull up on the bar until it clicks against the plates, then push the floor away.
  • Push, don’t yank. Jerking the bar off the floor bends the arms and throws the back out of position.
  • Lock out with the hips, not by leaning back.

Safety

  • Lower under control. Dropping a heavy deadlift from the top damages bars, plates and floors, and some gyms ban it. Keep hold of the bar to the floor.
  • Stop the set if your back rounds more than on your warm-ups. A rep that looks different is a rep that’s too heavy today.
  • Grip fails before the back? Use straps on the work sets, not the warm-ups.

Limits

Sumo, Romanian, deficit and stiff-leg deadlifts use the same ramp on a 20 kg bar. The trap bar has no standard weight, so set your gym’s bar (or 0 and track plates only). For a max attempt, add singles above 85 %.

In the app

In LiftLoggr, turn on Auto warm-up sets for the deadlift in the routine editor, or tap Add warm-up sets on the exercise during a workout. The ramp is built from the day’s first working set, with plates shown on every set. Warm-ups never count toward your deadlift records.

Questions

How many warm-up sets should I do for deadlifts?

Three or four: the bar, then about 50, 70 and 85 % of the first working set. 180 kg gives 20 × 10, 90 × 5, 125 × 3, 152.5 × 1. Many lifters pull the bar set as Romanian deadlifts, since the empty bar is far from the floor position.

Why does my first deadlift warm-up feel so low?

Plates smaller than 450 mm put the bar closer to the floor. 15 kg and 10 kg iron plates, and 25 lb or 35 lb plates, are smaller than full-size plates. Put the plates on blocks or other plates to bring the bar to standard height, or use full-size bumper plates if your gym has light ones.

Do I need deadlift warm-ups after squatting?

Yes, but fewer. Your hips and legs are warm. Skip the bar set and start at the 50 % set; keep the 70 and 85 % sets for the pull itself.

Should I use straps or a mixed grip on warm-ups?

No. Pull warm-ups double overhand. They train your grip and save the mixed grip, hook grip or straps for the sets that need them.

Should I touch and go on warm-ups?

Reset each rep from a dead stop, the way you'll pull your heavy sets. Warm-ups rehearse the start of the pull, and touch-and-go skips it.

Sources

  1. IPF Technical Rules (disc diameter, deadlift rules) powerlifting.sport
  2. Abad et al. 2011, General and specific warm-ups and leg-press 1RM pubmed.ncbi.nlm.nih.gov