LiftLoggr estimate
354.4 lb
Brzycki, from 315 lb × 5. The formula the app uses for estimated 1RM and PRs. RIR isn't used.
Other estimates (web only)
- Epley
- 367.5 lb
- RIR-adjusted: 2 RIR, as 7 reps to failure
- 378 lb
| % 1RM | Weight |
|---|---|
| 100 % | 354 lb |
| 95 % | 337 lb |
| 90 % | 319 lb |
| 85 % | 301 lb |
| 80 % | 284 lb |
| 75 % | 266 lb |
| 70 % | 248 lb |
| 65 % | 230 lb |
| 60 % | 213 lb |
| 55 % | 195 lb |
| 50 % | 177 lb |
| Reps | % 1RM | Weight |
|---|---|---|
| 1 | 100 % | 354 lb |
| 2 | 97.2 % | 345 lb |
| 3 | 94.4 % | 335 lb |
| 4 | 91.7 % | 325 lb |
| 5 | 88.9 % | 315 lb |
| 6 | 86.1 % | 305 lb |
| 7 | 83.3 % | 295 lb |
| 8 | 80.6 % | 285 lb |
| 9 | 77.8 % | 276 lb |
| 10 | 75 % | 266 lb |
| 11 | 72.2 % | 256 lb |
| 12 | 69.4 % | 246 lb |
Rounded to the nearest 1 lb. Reps table: Brzycki inverted, 1–12 reps.
Key takeaways
- 01Squat max ≈ weight × 36 ÷ (37 − reps). 140 kg × 5 → 157.5 kg.
- 02Estimate from sets at your real depth. Half reps inflate the number.
- 03High-rep squat sets end on breathing, not strength. Use 3 to 6 reps.
- 04Never test a squat max without safeties set or spotters.
On this page
Your squat max is about weight × 36 ÷ (37 − reps) from a set taken close to failure. 140 kg × 5 gives 157.5 kg; 315 lb × 5 gives 354.4 lb. That’s Brzycki, the formula LiftLoggr uses, valid up to 12 reps.
The calculator above is set to the squat. The first figure is the LiftLoggr estimate; Epley and the RIR-adjusted figure are labelled extras. Full rules: 1RM calculator.
Squat examples
| Set | Estimated max | Epley (extra) |
|---|---|---|
| 100 kg × 8 | 124.1 kg | 126.7 kg |
| 120 kg × 8 | 149 kg | 152 kg |
| 140 kg × 5 | 157.5 kg | 163.3 kg |
| 160 kg × 6 | 185.8 kg | 192 kg |
| 185 lb × 5 | 208.1 lb | 215.8 lb |
| 275 lb × 3 | 291.2 lb | 302.5 lb |
| 315 lb × 5 | 354.4 lb | 367.5 lb |
With RIR. 160 kg × 5 logged at 2 reps in reserve: the LiftLoggr estimate ignores RIR and reads 180 kg. The RIR-adjusted extra treats it as 7 reps to failure and reads 192 kg. The truth is usually between them, and nearer the lower figure if you tend to sandbag your RIR.
How accurate is it for the squat?
Less reliable than for the bench. In LeSuer et al. (1997), only one of seven equations, Wathan’s, predicted the tested squat max without a significant error. In Ribeiro et al. (2024), Brzycki matched the tested squat in young women; in men, Lombardi’s equation fit best. The squat has more ways to drift:
- Depth. The biggest error. A set where the last reps got shallow estimates a shallower max. Squat to the same depth on every rep, the depth you’d test at. Competition depth is the hip crease below the top of the knee.
- Breathing. Past 6 or 7 reps, squats get hard because of breathing and leg endurance, not just strength. A 12-rep set tells you less than a 4-rep set.
- Equipment. Belt, knee sleeves, wraps and shoes all change what you can lift. Estimate and test with the same kit.
- Bar position. High-bar and low-bar are different lifts with different maxes.
Use the estimate for planning and for spotting trends. If the same 5-rep set gives a higher estimate than four weeks ago, you’re stronger, whatever the true max is.
Testing a true squat max
- Warm up with the squat warm-up calculator: bar × 10, 50, 70 and 85 % of the expected max.
- Single at about 90 %. Rest 3 to 5 minutes.
- Single at about 95 %. If it was slow, stop and log it as today’s best.
- One attempt at the max.
Heavy single cues. Breathe in and brace before you unrack. Walk out in three steps. Set the feet, re-brace, and sit to your depth under control. Drive up with the chest and hips together; if the hips shoot up first, the bar tips forward. Rack the bar by walking into the uprights, not by aiming the hooks.
Safety
- Set the safeties or pins just below the bar at your bottom position, every set. Failing a squat into set pins is a non-event. Failing without them is dangerous.
- Know how to dump the bar if you train in a rack without safeties: push it backwards off the back as you step forward. Practise with the bar.
- Spotters on a max: two side spotters, one per end, or one behind who knows to hold the torso, not just the bar.
- Collars on for every set above the warm-ups.
In the app
LiftLoggr calculates this estimate for every completed squat set you log, keeps the best as a record, and charts the estimate over time on the exercise page. High-bar and low-bar squats are separate exercises in the catalog, so their estimates stay separate too.
Questions
How do I calculate my squat max from reps?
Use a set taken close to failure: weight × 36 ÷ (37 − reps). 140 kg × 5 gives 157.5 kg; 315 lb × 5 gives 354.4 lb. The formula stops at 12 reps.
Why is my estimated squat max higher than what I can actually squat?
Usually depth. If your rep sets cut depth as you tire, the estimate is for a higher squat than the one you'd test. Belts and knee sleeves on the rep set but not the test also do it.
How much should I squat?
Among raw competitive powerlifters in OpenPowerlifting, the median best squat is 185 kg for men in the 83 kg class and 105 kg for women in the 63 kg class. Most gym lifters are below that. Check yours in the strength standards tool.
Do high-bar and low-bar squats have the same max?
No. Most lifters squat a bit more low-bar. Estimate each from its own sets, and log them as separate exercises.
Should I use a 10-rep set for my squat estimate?
Only if that's all you have. Ten hard squats are as much a breathing and leg-endurance test as a strength test, so the estimate is less reliable than one from a hard set of 3 to 5.
Sources
- Brzycki 1993, Predicting a one-rep max from reps-to-fatigue doi.org
- LeSuer et al. 1997, Prediction equations for 1-RM in the bench press, squat and deadlift doi.org
- Ribeiro et al. 2024, Accuracy of 1RM prediction equations before and after training doi.org
- IPF Technical Rules (squat depth) powerlifting.sport
- OpenPowerlifting (competition data) openpowerlifting.org