7 muscle groups in the 10–20 sets range
| Muscle group | Sets | vs 10–20 |
|---|---|---|
| Chest | 8 | Under 10 |
| Back | 12 | 10–20 |
| Shoulders | 13 | 10–20 |
| Biceps | 10 | 10–20 |
| Triceps | 14 | 10–20 |
| Forearms | 2 | Under 10 |
| Quads | 10 | 10–20 |
| Hamstrings | 13 | 10–20 |
| Glutes | 14 | 10–20 |
| Calves | 4 | Under 10 |
| Abs and core | 3 | Under 10 |
| Lower back | 5 | Under 10 |
Each set counts 1 for the exercise's primary muscles and 0.5 for its other worked muscles (LiftLoggr exercise catalog). Count hard sets only: working sets close to failure, not warm-ups.
10–20 hard sets per muscle a week is a commonly cited range, drawn from dose–response research such as Schoenfeld, Ogborn & Krieger (2017): more weekly sets, more growth, with 10+ sets beating fewer.
Key takeaways
- 01One set counts 1 for each primary muscle and 0.5 for each secondary muscle.
- 02A muscle counts once per exercise.
- 03The common target is 10 to 20 hard sets per muscle group per week.
- 04Only count working sets: warm-ups don't count.
On this page
Count one set for each muscle the exercise mainly trains and half a set for each muscle it helps, add up the week, and compare each muscle with 10 to 20 hard sets. That is what the calculator above does, using the muscles listed for every exercise in the LiftLoggr catalog.
How to use it
- Add each exercise in your week, from the quick picks or the full catalog.
- Enter the total working sets for the week. Bench twice a week, 3 sets each time: 6.
- Read the sets per muscle group, and which side of 10 to 20 each one falls.
The URL holds your exercises and sets, so you can bookmark a week or send it to a training partner.
The rules, exactly
| Rule | Value |
|---|---|
| Primary muscle | 1 set per set |
| Secondary muscle | 0.5 set per set |
| Same group twice in one exercise | Counted once, at the higher value |
| Range | Below 10 · 10 to 20 · above 20 |
| Source of muscles | The exercise’s primary and secondary muscles in the LiftLoggr catalog |
The catalog’s muscles fold into twelve groups:
| Group | Includes |
|---|---|
| Chest | Chest, upper chest |
| Back | Lats, upper back, traps |
| Shoulders | Shoulders, rear delts |
| Biceps, triceps, forearms | Forearms include grip |
| Quads, hamstrings, glutes, calves | — |
| Abs | Abs, core, obliques |
| Lower back | Lower back |
Catalog entries that don’t name a single muscle, like “full body”, “legs” or “hips”, aren’t counted.
Why half sets? Pelland et al. (2026) pooled 67 studies and compared three ways of counting the indirect work, like triceps in a bench press: as a full set, as half, or as nothing. Counting it as half fitted the results best. Their models also show more growth with more weekly sets, with diminishing returns, and those returns flatten sooner for strength than for size.
Worked example: an upper/lower week
Four days, each exercise on two of them. Weekly sets in brackets.
Bench press (6), high-bar squat (6), Romanian deadlift (4), pull-up (6), barbell row (6), overhead press (4), dumbbell lateral raise (6), seated leg curl (4), dumbbell curl (4), triceps pushdown (4), standing calf raise (4).
| Group | Sets | Where from | Range |
|---|---|---|---|
| Triceps | 14 | Bench 6 + press 4 + pushdown 4 | Within |
| Shoulders | 13 | Press 4 + lateral raise 6 + bench 6 × 0.5 | Within |
| Back | 12 | Pull-up 6 + row 6 | Within |
| Hamstrings | 11 | RDL 4 + leg curl 4 + squat 6 × 0.5 | Within |
| Glutes | 10 | Squat 6 + RDL 4 | Within |
| Biceps | 10 | Curl 4 + pull-up 6 × 0.5 + row 6 × 0.5 | Within |
| Chest | 8 | Bench 6 + press 4 × 0.5 | Below |
| Quads | 6 | Squat 6 | Below |
| Lower back | 5 | RDL 4 × 0.5 + row 6 × 0.5 | Below |
| Calves | 4 | Calf raise 4 | Below |
| Abs | 3 | Squat 6 × 0.5 | Below |
| Forearms | 2 | Curl 4 × 0.5 | Below |
The program looks balanced on paper. The count says otherwise: quads get 6 sets while triceps get 14. Adding 4 sets of leg press puts quads at 10. Lower back, abs and forearms sitting low is normal; heavy compound lifts train them in ways a set count misses.
How to read the result
| Weekly sets | What it usually means |
|---|---|
| Under 5 | The lowest band in Schoenfeld et al. (2017); the smallest gains |
| 5 to 9 | Enough for a beginner to progress |
| 10 to 20 | The range most programs aim for |
| Over 20 | Can suit a priority muscle for a block. Gains per extra set shrink; watch recovery |
Don’t chase a number for every group. Pick the muscles you care about, get them into the range, and keep the rest reasonable.
Limits
- Sets aren’t all equal. A set stopped 5 reps short of failure counts here like one taken to RIR 1. Count only hard sets.
- The 0.5 is an average. A close-grip bench is more triceps than a wide-grip one. The catalog lists primary and secondary muscles, not percentages.
- The range isn’t a law. It comes from group averages. Your recovery, sleep and training age move it.
In LiftLoggr
LiftLoggr routines hold your exercises, sets and rep ranges, with a weekday schedule. Plan the week here, then build it as a routine. Starter splits are included: push/pull/legs, upper/lower and full body. Read more on sets per muscle per week.
Questions
How many sets per muscle group per week?
Most lifters grow well on 10 to 20 hard sets per muscle group a week. More volume tends to mean more growth, with diminishing returns. Beginners progress on less; start near 10 and add sets when progress stalls.
Does a bench press count as chest, shoulder and triceps volume?
In this calculator a bench press set counts 1 for chest and triceps, its primary muscles in the LiftLoggr catalog, and 0.5 for shoulders. Recent research found that counting indirect sets as half predicts results better than counting them fully or not at all.
What counts as a hard set?
A working set taken within about 0 to 3 reps of failure. Warm-ups and easy back-off sets far from failure don't count.
Is 6 sets per muscle enough?
It's enough to keep progressing as a beginner or to maintain size. Most people grow faster with more. If one muscle sits below 10 while others are near 20, move a few sets across.
Why is my quad volume so low with squats in the program?
One squat movement for 6 sets is 6 quad sets. Glutes get the same 6, hamstrings and core get 0.5 each. Add a leg press, lunge or leg extension to reach 10.
Sources
- Pelland et al. 2026, The resistance training dose response: weekly volume and frequency (Sports Medicine) pubmed.ncbi.nlm.nih.gov
- Schoenfeld et al. 2017, Dose-response between weekly volume and muscle mass pubmed.ncbi.nlm.nih.gov