Get the app (opens the App Store in a new tab)

LiftLoggr

Lifting glossary: the terms in a training log

Short definitions, in logbook order of importance: what the term means and what to write down.

Key takeaways

  1. 0191 terms, A to Z, each in one to three sentences.
  2. 02Where a guide or calculator goes deeper, the term links to it.
  3. 03Terms the LiftLoggr app uses say how the app handles them.
On this page

A training log uses a small vocabulary over and over. These are the terms you’ll meet in programs, on this site and in the LiftLoggr app, defined in plain words. Each definition says what the term means and, where it matters, what to write down.

0–9

1RM

One-rep max: the heaviest weight you can lift for one full, clean rep. Most lifters estimate it rather than test it; the 1RM calculator does that from any set of 1 to 12 reps.

5/3/1

A strength program built on four main lifts and a training max, with waves of 5, 3 and 1 reps and an AMRAP final set. See the 5/3/1 program and the 5/3/1 calculator.

5×5

Five sets of five reps at the same weight, the core of several beginner barbell programs that add weight every session. See 5×5.

A

Accessory exercise

Any exercise that supports the main lifts: rows, curls, lunges, triceps work. Usually done after the main lift, for more reps.

AMRAP

As many reps as possible. One set taken to the last clean rep, used to test strength or decide the next increase.

Autoregulation

Adjusting load or volume on the day based on how the sets actually feel, usually with RIR or RPE, instead of following fixed numbers.

B

Back-off set

A lighter set, or group of sets, done after the top set of the day for extra volume. Often 10–20% under the top set. See set types.

Barbell

A long bar that takes plates on both ends. A men’s Olympic bar weighs 20 kg (about 45 lb); women’s bars and technique bars are lighter. See how much a barbell weighs.

Belt

A stiff lifting belt worn around the waist. You brace against it to make the trunk more rigid in squats and deadlifts. Note in your log which sets used one.

Bilateral

Both limbs working together, as in a squat or bench press. Opposite of unilateral.

Bracing

Taking a breath into the belly and tightening the trunk before a rep, so the spine stays still under load.

Bumper plates

Thick rubber-coated plates that can be dropped from overhead. Mostly 450 mm in diameter whatever the weight, so light bumpers sit wider on the bar than steel plates.

C

Chalk

Magnesium carbonate rubbed on the hands to keep the grip dry.

Cluster set

A set broken into small groups of reps with 10–30 seconds of rest inside it, so more reps are done with a heavy load.

Collars

Clips that hold the plates on the bar. Spring clips weigh almost nothing; competition collars weigh 2.5 kg each. See the plate calculator.

Compound exercise

An exercise that moves more than one joint, such as a squat, row or press. Opposite of isolation.

Concentric

The lifting part of a rep, when the working muscle shortens: standing up out of a squat.

D

Deadlift

Lifting a loaded bar from the floor to standing with straight arms. Variations include sumo, trap bar and Romanian. Swaps are covered in deadlift alternatives.

Deficit

Standing on a plate or platform so the bar starts lower, making the range of a deadlift or push-up longer.

Deload

A planned easier week of lighter loads, fewer sets or both, to shed fatigue. Surveyed strength and physique athletes deloaded for about a week every five to six weeks. See deload week.

DOTS

A bodyweight-adjusted score used by several powerlifting federations to compare lifters of different sizes. Higher is better.

Double progression

Progress reps first, then weight: work up to the top of a rep range on every set, then add load and start again at the bottom. LiftLoggr pre-fills the next weight this way. See double progression.

Drop set

A set continued straight after reaching the target, with the weight reduced and no rest. LiftLoggr logs drop sets as their own set type. See how to log drop sets.

E

e1RM

Estimated one-rep max, calculated from a set of several reps. LiftLoggr uses the Brzycki formula on completed working sets of 12 reps or fewer.

Eccentric

The lowering part of a rep, when the working muscle lengthens under load.

Equipped

Powerlifting in supportive suits and shirts that store energy and add weight to the lift. Opposite of raw.

Exercise substitution

Replacing one exercise with another that trains the same pattern. Log the substitute as its own exercise. See bench press alternatives.

F

Failure

The point where you can’t complete another rep with good form. A meta-analysis found no clear muscle growth advantage for training to momentary failure over stopping short of it.

Frequency

How many times a week a muscle or lift is trained.

Full body

A split where every session trains the whole body, usually three days a week. See 3-day full body.

G

Giant set

Three or more exercises done back to back with no rest between them. See set types.

Grip

How the hands hold the bar. Overhand (pronated), underhand (supinated), neutral (palms facing), mixed (one of each) or hook (thumb under the fingers).

GZCLP

A linear progression program with three tiers of exercises and rep schemes that change as you stall. See GZCLP.

H

Hard sets

Working sets taken close to failure, usually within about 0–4 reps in reserve. The usual way to count training volume. See sets per muscle per week.

Hinge

A movement pattern where the hips move back and forward while the spine stays still: deadlifts, Romanian deadlifts, swings.

Hypertrophy

Muscle growth. Training for hypertrophy usually means hard sets in the 6–30 rep range.

I

Intensity

How heavy the load is relative to your max, usually written as a percentage of 1RM. Not the same as effort.

IPF GL points

The International Powerlifting Federation’s formula for comparing lifters across bodyweight classes, which replaced its earlier formulas. Used to rank best lifters at IPF meets.

Isolation exercise

An exercise that moves one joint, such as a curl, leg extension or lateral raise.

J

Junk volume

Sets too easy, or too many, to add training effect. Usually sets stopped far from failure.

K

Knee sleeves

Neoprene sleeves worn over the knees for warmth and support in squats. Allowed in raw powerlifting.

L

Linear progression

Adding the same small amount of weight every session or week. It works for beginners until it stalls. See 5×5 and GZCLP.

Lockout

The top of a lift, where the joints finish straight: arms locked on a press, hips through on a deadlift.

M

Macrocycle

The longest training block, often a year or the time until a competition.

Mesocycle

A training block of several weeks with one goal, often 4–8 weeks, usually ending in a deload.

Microcycle

The shortest repeating unit of a program, usually one week.

Myo-reps

An activation set close to failure, then several mini-sets of a few reps with a few breaths of rest between them.

N

Negative

A rep that only does the lowering part, slowly. Used to build toward pull-ups or dips. See pull-up alternatives.

O

Overreaching

Short-term drop in performance from training harder than you can recover from. A deload usually fixes it.

P

Pause rep

A rep with a deliberate stop, usually at the bottom, to remove the bounce and train the weakest position.

Periodization

Planning training in blocks that change volume and intensity over time.

PHUL

Power Hypertrophy Upper Lower: a four-day split with two heavy and two higher-rep sessions. See PHUL.

Plate math

Working out which plates go on each side of the bar: total minus bar, divided by two. The plate calculator does it for kg and lb.

Plateau

A period where a lift stops improving despite training. LiftLoggr suggests a deload of about 10% after three sessions in a row below the bottom of the rep range at the same weight.

PPL

Push/pull/legs: a split with one day for pressing, one for pulling and one for legs, run three or six days a week. See push/pull/legs.

PR

Personal record: your best on an exercise. LiftLoggr flags one when a session’s estimated 1RM beats your previous best for that exercise. A first-ever session is a baseline, not a PR.

Progressive overload

Doing more over time, through weight, reps or sets, so the body keeps adapting. See how to track progressive overload.

Pyramid

Sets that change weight each time: up in weight and down in reps, or the reverse.

R

Range of motion

How far a joint moves in a rep. Write it down when you change it, such as squatting to a box.

Raw

Lifting without supportive suits or shirts. Belts, knee sleeves and wrist wraps are usually still allowed.

Rep

One complete repetition of an exercise.

Rep range

The span of reps a program asks for, such as 8–12. The basis of double progression.

Rest interval

The time between sets. See rest between sets.

Rest-pause

Taking a set to near failure, resting 10–20 seconds, then doing more reps with the same weight.

RIR

Reps in reserve: how many more reps you could have done. RIR 2 means two left in the tank. LiftLoggr logs it per set when Log reps in reserve is on. See RIR vs RPE and the RIR chart.

RPE

Rate of perceived exertion. In lifting, a 1–10 scale where 10 is a max effort and RPE 8 means about two reps in reserve. LiftLoggr logs RIR, not RPE.

S

Set

A group of reps done without rest.

Smith machine

A barbell fixed to vertical rails with hooks to rack it at any height. Log Smith lifts as their own exercises; the loads don’t match a free bar.

Spotter

A person ready to help if a rep fails, mainly on the bench press and squat.

Sticking point

The part of a rep where the bar slows most or stops.

Straight sets

All working sets at the same weight and reps, with rest between them.

Strength standards

Tables that place a lift relative to bodyweight against other lifters. See strength standards.

Superset

Two exercises done back to back, then rest. LiftLoggr labels them A1/A2 and starts rest after the round. See how to log supersets.

T

Tapering

Reducing training volume before a test or competition so you arrive rested.

Technical failure

The point where the next rep would break form, before true muscular failure.

Tempo

How fast each part of a rep is done, often written as four numbers, such as 3-1-1-0 for lowering, bottom pause, lifting and top pause in seconds.

Time under tension

Total seconds the muscle works during a set.

Top set

The heaviest set of the day for an exercise, usually followed by back-off sets. See set types.

Training log

A record of every session: exercise, weight, reps, sets and notes. See how to track workouts or print a workout log.

Training max

A deliberately conservative max, usually 85–90% of your true 1RM, used to set percentages in programs like 5/3/1.

Trap bar

A hexagonal bar you stand inside, used for deadlifts and carries.

U

Undulating periodization

Changing the rep scheme from session to session within a week, such as heavy on Monday and lighter on Friday.

Unilateral

One limb at a time, as in split squats or one-arm rows. Log the reps for one side.

Upper/lower

A split that alternates upper-body and lower-body days, usually four days a week. See upper/lower.

V

Velocity-based training

Using bar speed, measured by a device, to set loads and decide when to stop a set.

Volume

How much work you did. Usually counted as hard sets per muscle per week. See the weekly volume calculator.

Volume load

Sets × reps × weight, a single tonnage number for a session or exercise. LiftLoggr can count warm-up sets and both dumbbells in this total, each with its own setting.

W

Warm-up ramp

The sets that work up from a light weight to the first working set. LiftLoggr builds them from your first working set. See warm-up sets and the warm-up calculator.

Wilks

An older formula for comparing powerlifters of different bodyweights. The IPF now ranks lifters with IPF GL points instead.

Working set

A set that counts toward the training goal, as opposed to warm-up sets.

Wraps

Elastic wraps around the knees or wrists. Wrist wraps support the wrist on presses. Knee wraps add rebound and are only allowed in some divisions.

Questions

What is the difference between 1RM and e1RM?

A 1RM is the most you have actually lifted for one rep. An e1RM is an estimate calculated from a heavier set of several reps, such as 100 kg × 5. LiftLoggr uses the Brzycki formula and only estimates from sets of 12 reps or fewer.

What is the difference between RIR and RPE?

RIR counts the reps you had left. RPE rates effort on a 1 to 10 scale; in the lifting version, RPE 8 means about 2 reps in reserve. They describe the same thing from opposite ends.

What does AMRAP mean?

As many reps as possible: one set taken to the last rep you can do with good form, usually the final set of a 5/3/1 or GZCLP day.

Sources

  1. Zourdos et al. 2016, resistance-training-specific RPE scale measuring repetitions in reserve (J Strength Cond Res) pubmed.ncbi.nlm.nih.gov
  2. Helms et al. 2016, application of the RIR-based RPE scale (Strength Cond J) pubmed.ncbi.nlm.nih.gov
  3. Refalo et al. 2023, proximity to failure and muscle hypertrophy, meta-analysis (Sports Med) pubmed.ncbi.nlm.nih.gov
  4. Rogerson et al. 2024, deloading practices in strength and physique sports (Sports Med Open) pubmed.ncbi.nlm.nih.gov
  5. International Powerlifting Federation, IPF GL formula powerlifting.sport